|
|
Note:
Tools listed here are for example. Equivalent brands can be used instead.
Auto Troubleshooter
-
Actron CP7677 Auto Troubleshooter
- Tests engine RPM and dwell
- Measures AC/DC voltage, DC current and resistance
- Tests continuity, wiring and diodes
- Tests starting & charging, ignition and fuel delivery systems
|
|
Ignition Module and Sensor Testor
- Actron CP9087 Ignition Module and Sensor Testor
- Test ignition modules (ECM) and igniters
- Tests sensors including O2, MAP, MAF, knock and crankshaft sensors (ie: Distributor pickup sensor)
- Tests continuity, wiring and diodes
Note:
This tool is sort of the missing link many are looking for.
Allows you to check the ECM (Section 3 using the Magnetic Reluctance Pick-up hookup on page 3-9 of the
tester manual).
Allows you to check the Distributor Pick-up sensor (Section 2, page 2-46 of the tester manual,
Magnetic Reluctance version)
Unfortunatly this has been discontinued and may be diffficult to locate.
|
|
Timing Light
Timing lights come in Good, Better and Best Categories.
- Good -
Actron CP7527
When using this type of timing light (no dial back capability) to perform the tuning procedures listed here, you
will need to add a 0-60 degree timing tape attached to the harmonic balancer.
- Better - Actron CP7528 Timing changes are read off the rear dial.
- Best - Actron CP7529 Timing changes and engine RPM values are read off rear digital display.
|
|
Hand Operated Vacuum Pump
- Good -
Actron CP7830
Used to set up vacuum advance curve, check EGR valve, etc.
|
|
- Better -
Actron CP7835
Used to set up vacuum advance curve, check EGR valve, bleed brakes, etc.
|
|
Feeler Gauge - Steel and Non-Magnetic (Brass) Blades
-
Alltrade 648518 Combo Tune-Up Gauge
- For measuring a variety of clearances. Gauge set contains flat and wire loop blades, non-magnetic
brass blades and spark plug gap adjusting tool.
- Steel blades include: 0.010, 0.012, 0.015, 0.016, 0.017, 0.018, 0.019, 0.020, 0.022, 0.024, 0.025,
0.026.
- Brass blades include: 0.006, 0.008, 0.010, 0.012, 0.014, 0.016. - (Used for setting Reluctor Gap)
- Wire loop blades include: 0.025, 0.030, 0.034, 0.035, 0.040, 0.045.
- Flat blades have metric and standard measurements on blades. Meets Fed Spec. GGG-G-17c
|
|
Lock Ring Pliers
-
KD Tools 2534 Lock Ring Pliers
Used for removing the snap ring at the top of the distributor shaft of a MOPAR distributor. General
purpose Snap Ring Pliers.
|
|
Vacuum Gauge
|
|
Wideband A/F Meter
|
|
|